Barco MDNG-5221, Руководство пользователя

Страница: 16 / 52

3. Display installation
5. Remove the four screws fi xing the foot while supporting the foot.
6. Attach the arm stand fi rmly to the panel using 4 screws M4 x 8 mm.
3.7 First time starting up
Overview
You are now ready to start up your Nio 5MP LED Display for the fi rst time.
1. Switch on your Nio 5MP LED Display as described in "Standby switching", page 16.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is
fi nished.
Your Nio 5MP LED Display will be running in a basic video mode at a default refresh rate
when
fi rst time starting up. If you are using a Barco display controller, please consult
the user guide delivered with it to install the drivers, software and documentation. When
this is done, your display will automatically detect the connected video input signal(s)
and apply the correct video mode and refresh rate.
14 K5902091 NIO 5MP LED DISPLAY 09/01/2015