Barco MDFC-8232 3SW, Руководство пользователя

Страница: 43 / 70

43 R5913170 /00 MDFC-8232
• Side by Side
• Full Side by Side
DisplayPort mode DP 1.1 dual must be selected when the 3D format is set to Dual Stream
(see “ DisplayPort mode ” , page 35).
To select the 3D format
1. Bring up the OSD main menu.
2. Navigate to the
3D Config. menu.
3. Enter the 3D format submenu.
4. Select one of the available formats and confirm.
5.6.4 H parallax
About H parallax
Horizontal shift of the right image view compared to the left view (LCD native format – Left view on top).
H parallax can assume values between -127 and 127.
To adjust the H parallax
1. Bring up the OSD main menu.
2. Navigate to the
3D Config. menu.
3. Enter the H parallax submenu.
The command bar H parallax is highlighted.
4. Set the level as desired and confirm.
5.6.5 V parallax
About V parallax
Vertical shift of the right image view compared to the left view (LCD native format – Left view on top).
V parallax can assume values between -15 and 15.
To adjust the V parallax
1. Bring up the OSD main menu.
2. Navigate to the
3D Config. menu.
3. Enter the V parallax submenu.
The command bar V parallax is highlighted.
4. Set the level as desired and confirm.
5.6.6 DVI output view
DVI output view
This setting allows to select which view of the image has to be cloned to a FHD signal on the DVI output
connector.
The available DVI output views selectable are:
• Right view
• Left view
DVI output must first be enabled. See “ DVI output ” , page 41 for more information.
To select the DVI output view
1. Bring up the OSD main menu.
2. Navigate to the
3D Config. menu.
Advanced operation