Barco MCM-50, Руководство пользователя

Страница: 32 / 147

6. Setup and configuration
MENU
BACK
ENTER
1 2 + -
+ -
+ -
+ -
+ -
3 4
5 6
7 8
9
PAUSE
AUTO IMAGE
SDI
DVI
VIDEO
RGB
S-VIDEO
PC
LOGO PIP
0
CONTR
TINT
PHASE
COLOR
BRIGHTN
PIP
ADJUST
Standby button
Image 6-5
RCU: standby button
Switching the MCM-50 from standby to active state?
Press the standby button on the RCU (do not press longer than 1 second).
6.4 Setting the MCM-50 address
Introduction
The MCM-50 has two different IR addresses:
• Common address.
• Device address;
The Common address is typically used to address multiple MCM-50s at once or to address the device at its very fi rst use. By
default, the common address is set to 0 , but it can be set to 1 as well to avoid interaction with other non-Barco devices, programmed
to the same IR address.
The Device address is used to address one MCM-50 at a time. This address can be set in the range 0..255 (default is 1 ). It must
be taken into account however that a standard RCU can only communicate with devices having their address set in the range 0..9.
The MCM-50 address and the RCU address must be set to the same value to allow communication.
Setting the MCM-50 address
1. In the OSD, navigate to Installation > IR address...
and press ENTER to select.
Image 6-6
28 R5909057 MCM-50 17/05/2016