Barco K9352021, Руководство пользователя

Страница: 22 / 62

K5902133 (451920612484) /03 MDSC-8255
22
4.1 On/Off switching
To switch on/off your display:
1. Power on/off your display using the mains switch located on the back of the display.
While your display is on, press and hold the stand-by key for approximately 1 second to put the
display in the stand-by mode.
While your display is in stand-by mode, press and hold the stand-by key for approximately 1 second
to activate the display.
4.2 Power mode LED
About the power mode LED
The behavior of the power LED shows the status of the unit:
• Off: Hard power OFF (power unplugged or switched off through rocker switch)
• Amber slow blinking: Soft power OFF (switched off by using the stand-by key ( ))
• Full amber: Display is in power save mode (backlight and LCD off)
• Green/amber blinking: Searching for signal
Note: When Power save mode is enabled, the display will automatically go into power save mode after 10
seconds of searching without signal.
• Full green: Display has a valid input signal.
4.3 OSD menu activation
To activate the OSD menu
Press the key on the display.
As a result, the OSD main menu comes up in the bottom right corner of the screen. If no further actions are
taken within the following 30 seconds, the OSD menu will disappear again.
If after pressing the key, the OSD lock window appears then this means that the OSD lock has been
enabled. Refer to “ Control lock: OSD menu locking/unlocking ” , page 24 for more information and instructions
to unlock the OSD menu.
The time-out of the OSD menu automatic close function can be adjusted or disabled in the OSD
menu (
OSD Time-out ).
The OSD menu position can be adjusted in the OSD menu ( OSD Hor. Pos. and OSD Vert. Pos. ).
4.4 OSD menu navigation
OSD menu structure explained
Below is an example of the OSD menu structure:
Daily operation