Barco IOSONO ONE Series, Инструкция по установке и эксплуатации

Страница: 29 / 35

6. Use Cases
Image 6-2
Audio tab with active Noise sequence in Setup page of Play Con
fi g
To play back the noise sequence
1. Go to the Audio Tab on the setup page (wrench symbol).
2. Press Activate in Noise Sequence - the output level meters in the Status page ( i symbol) indicate output level on a single
channel. Connected loudspeakers should play back the noise signal accordingly.
3. Control the noise sequence with
- Activate - for start and stop.
- Loop Playback - button for an automated sequence to all speakers respectively.
- Forward and Backward buttons to step through individual output channels.
While the noise sequence is activated, all other control elements except for the main volume controls are
deactivated.
6.4 Create And Play A Clip List
About
One of the main features of the IOSONO ONE is processing clip lists.
To create a clip list
1. Connect to the IOSONO ONE and enter Play Con fi g
2. Go to the setup page (wrench symbol) and the Clip Lists tab
3. Press New to create a new clip list - rename it (per default Cliplist0)
4. Press + to add clips to the clip list
5. Deselect the Setup button to return to the main page
Play a clip list
1. Select a clip list - press the Cue button the clips of the selected clip list are shown in the show window
R5906747 IOSONO ONE 16/05/2017 25