![background image](http://html1.mh-extra.com/html/barco/imagepro-ii-jr/imagepro-ii-jr_user-manual-addendum_3876304084.webp)
ImagePRO-II • User’s Guide
69
4. Menu Orientation
Configuring Outputs
~
Channel
— If you have the 3D/Dual Channel option installed, you can
select the channel to which these offsets will apply. If you are using the
standard ImagePRO-II, this option is not available.
~
H Offset
— Sets the horizontal offsets, in increments of +/- one-half
line
,
in pixels. The range depends on the output format.
~
V Offset
— Sets the vertical offsets, in increments of +/- one-half
frame
.
The range depends on the output format.
•
Status
— The current status.
With the 3D/Dual Channel mezzanine installed and the system mode set to
Dual2K
, the
Genlock Submenu
also includes two lines for setting the Channel A and B source.
Figure 4-48.
Genlock Submenu in Dual-Channel Mode
In this mode:
•
CHA Source
defaults to the selected input. It can also be set to
Freerun
,
Ext
(ernal), or any of the other inputs.
•
CHB Source
defaults to
Lock to A
. It can also be set to
Freerun
.
p~îáåÖ=~å=lìíéìí=`çåÑáÖìê~íáçå=
To save the custom output configuration of the selected output, select
Save Config
from
the
Output Menu
. The settings are saved in non-volatile memory, and the save persists
across power cycles.
With the 3D/Dual Channel mezzanine installed and the system mode set to
Dual2K
, the
Out Save Config Submenu
appears when you select
Save Config
from the
Output
Menu
.
Out Save Config
supports saving your configuration files on a per-channel basis.
The configuration is saved on every output mapped to the selected channel.
Figure 4-49.
Out Save Config Submenu (sample)
G E N L O C K
> C H A S o u r c e I n 6 ( S D I - 2 )
C H B S o u r c e
L o c k t o A
H / V O f f s e t > >
H D - 1 5 S C P h a s e n / a
C o m p S C P h a s e n / a
C H A S t a t u s N o S y n c
C H B S t a t u s L o c k e d
Note
Output settings revert to the last
saved
state when you power
up the ImagePRO-II. If you do not save your settings, they
are not restored.
OUT SAVE CONFIG A
> Channel A
Save Config