60
ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
^ÇàìëíáåÖ=lìíéìí=qáãáåÖ
From the
Output Menu
, select
Timing Adjust
to display the
Output Timing Adjust
Submenu
. On this submenu, shown in the following illustration, you can change the
selected output’s total, active and sync settings, and reposition video on the output.
Figure 4-34.
Output Timing Adjust Submenu (sample)
In dual-channel mode, the
Out Timing Adjust Submenu
includes a field for selecting the
channel to work with.
In either mode, your settings:
•
Do not result in cropping the image
•
Do not change the image aspect ratio
•
Must be within the range of timings supported by the output display, to avoid loss
of signal
•
Update the output Area of Interest
On this menu:
•
H Total
— Adjusts (in pixels) the total pixel count per line for the selected output.
•
H Position
— Adjusts (in pixels) the offset of the start of the output active area
from H sync.
•
H Active
— Adjusts (in pixels) the horizontal size of the output active area.
•
H Sync
— Adjusts (in pixels) the H sync width.
•
V Total
— Adjusts (in lines) the total line count per frame.
Note
All but the most advanced users are advised to avoid
changing the output timing values.
OUT TIMING ADJUST
> H Total
2200
H Position
192
H Active
1920
H Sync
88
V Total
1125
V Position
41
V Active
1080
V Sync
5
OUT TIMING ADJUST
A
> Channel A
H Total
2200
H Position
192