![background image](http://html1.mh-extra.com/html/barco/imagepro-ii-jr/imagepro-ii-jr_user-manual-addendum_3876304034.webp)
ImagePRO-II • User’s Guide
19
3. Hardware Installation
Installation
fåëí~ää~íáçå
With five input sources and six output connectors, there are many possible ways to
configure an ImagePRO-II installation. The following figure illustrates one possible
installation for the ImagePRO-II.
Figure 3-1.
Diagram of an ImagePRO-II Installation
In this installation:
•
Each front-panel input button maps to the corresponding input connector on the
rear panel. The ImagePRO-II’s input connectors support a range of signal types
and standards, including analog and digital NTSC, PAL, and SMPTE, as well as
HDMI, DVI, and DisplayPort. Input resolutions up to WQXGA (2560x1600) are
supported. For more information about each input, refer to
•
You can connect a variety of digital and analog devices to the ImagePRO-II’s
input connectors, including video cameras, PCs and laptops, notebooks or
tablets, Blu-ray players, and DVD players.
•
Six rear-panel output connectors display video in resolutions up to WQXGA
(2560x1600) at frame rates up to 120 Hz for 1080p formats. For more information
about each output, refer to
•
Output display types include HD and standard definition monitors and screens
(both analog and digital), plasma displays, and digital projectors.
•
The ImagePRO-II processes only one input source at a time. If you connect
multiple output display devices, only one source image is output.
•
You can further refine the placement of the image on the output displays using an
Area of Interest, as described in
on page 56 in
ImagePRO-II
Input 3
HDMI
Input 2
HD-15
Input 1
DVI-I / Universal Analog
Input 4
DisplayPort
Input 5
SDI-1
Output 5
SDI-1
Output 2
HD-15
Output 3
HDMI
Output 1
DVI-D