ImagePRO-II • User’s Guide
117
4. Menu Orientation
Operating the ImagePRO-II in 3D Mode
~
Left/Right.
The complete left and right images are displayed on different
output connectors. You can use this option with the following pairs of
connectors:
•
The
DVI and HDMI
connectors, with the DVI as the left image
by default, and the HDMI as the right image by default.
•
The
SDI 1 and SDI 2
connectors, with SDI1 as the left image by
default and SDI2 as the right image by default.
4)
If desired, scroll to
3D Swap
to swap the left and right output video.
5)
To invert the left and right sync signals, scroll to
3D Sync Invert
and select
On
.
6) 3D Sync Delay
allows you to adjust delay times for specific 3D glasses or
systems. The options are 0 to 100, in video lines.
7)
When prompted, save your output configurations.
mêçÅÉëëáåÖ=aì~äJpíêÉ~ã=Pa=sáÇÉç
The ImagePRO-II uses two sets of connectors to process dual-stream 3D video:
•
DVI and HDMI inputs and outputs
Inputs 1
and
3
(DVI-I and HDMI) work jointly to input separate left and right 3D
signals as two single-link DVI signals, at up to 165 megapixels per second.
By default, these signals are displayed with the left eye on the DVI-I output, and
the right eye on the HDMI output.
•
SDI 1 and SDI 2 inputs and outputs
Inputs 5
and
6
(SDI 1 and SDI 2) work jointly to input separate left and right 3D
signals.
By default, these signals are displayed with the left eye on the SDI 1 output, and
the right eye on the SDI 2 output.
For both sets of connectors, you can swap the left and right signals so that, for example,
the right-eye video is displayed on the
SDI 1
output and the left-eye video is displayed on
the
SDI 2
output.
In dual-stream mode, the inputs in a pair are locked and must be in the same format. You
cannot adjust outputs separately.
pÉííáåÖ=ré==íÜÉ=fã~ÖÉmolJff=íç=aáëéä~ó=aì~äJpíêÉ~ã=Pa=sáÇÉç
To set up the ImagePRO-II to display dual-stream 3D video, use the following
procedure:
1.
Verify that the connector pairs you wish to use are connected — either the
DVI-I
and HDMI
inputs and outputs, or the
SDI 1 and SDI 2
inputs and outputs.
2.
On the
System Menu
, set
System Mode
to
3D
. Save this configuration.
3.
On the
Output Menu
, select
3D Mode
and choose a 3D format. The options are:
Side
Top/Bottom
Sequential
Left/Right
Note
The output 3D Mode must match the input 3D Mode.