6. Tile reassembling
6.8
Installing the power assembly
Ensure that the controller unit is installed before installing the power assembly.
Necessary tools
•
Torx T20.
•
7 mm nut driver.
How to install the power assembly upon the module base plate ?
1. Place the power assembly (I) upon the module base plate (F). The fan must be at the top of the tile.
Caution:
Be careful with the board to board connectors between the power unit and the controller unit underneath.
P
I
F
Image 6-15
2. Fasten the power assembly (I) with eight screws (P) to the module base plate. Two screws at the left of the support plate, two
at the right, one at the top and tree on the power unit.
44
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007
Содержание ILite 6
