Barco IEX Series, Инструкция по установке и эксплуатации

Страница: 36 / 80

R5915190 /01 IEX series 36
Image 4 – 20 Selecting position of new module
Module Size
：
Set the size of the module in a cabinet. The software determines each module
arrangement based on module size and cabinet size.
4. Adjust the coefficients (similar to the steps of coefficient adjustment in setting coefficients for a new scan
board). For more info see
“ Setting Coefficients for a New Receiving Card ” , page 33 , step 3-4.
5. Save the correction coefficients to the hardware so that they are retentive after a power failure. See
“ Setting Coefficients for a New Receiving Card ” , page 33 , step 4-6.
Image 4 – 21 Obtaining correction coefficients for a new module
4.3.7 Replace Module with Flash
About Flash
The module of IEX has Flash, which can save the calibration coefficient. After replacing the module, make
sure that the receiving have read coefficient from the Flash and save.
How to replace
1. Click Setting on the main window.
LED Display Control Setting