Barco IEX Series, Инструкция по установке и эксплуатации

Страница: 32 / 80

R5915190 /01 IEX series 32
• Auto Adjustment by Hardware
After adjustment is finished, click Save to HW to save the adjustment results to the hardware.
Manual adjustment
Select Manual and adjust the brightness by dragging the scroll bar below Brightness Adjustment or directly
modifying the brightness value (the maximum value is 255) next to the scroll bar.
Image 4 – 11 Manual adjustment
Display Quality : Includes Soft mode and Enhanced mode. The Soft mode is generally used for indoor LED
displays while the Enhanced mode is used for outdoor LED displays.
Gamma Adjustment : Includes Mode A and Mode B. The LED display in Mode A can light up earlier than that
in Mode B.
Gain : For chips with current gain function, adjusting the current gain can improve the chip ’ s current output.
RGB brightness : Adjusts the brightness of Red (R), Green (G) or Blue (B) separately.
Automatic adjustment
Schedule , Auto , and Auto Adjustment by Hardware are automatic adjustment modes. Automatic adjustment
function is not recommended for indoor LED display products because the indoor environment has stable
ambient light and is rarely affected by the ambient brightness. If you really need to use this function, you can
configure this function by using the wizard.
4.3.4 Correction Coefficient Management
About correction coefficient
The IEX series products have been subject to correction before shipment. To ensure the optimum displaying
effect of the screen, you need to activate the correction function when using the LED display, and to reload the
correction coefficients after replacing the modules or receiving card. This Section introduces how to upload
the correction coefficients after replacing the modules or receiving card.
On the main window, click Calibration to display the screen calibration interface.
Image 4 – 12 Main window advanced user - Calibration
Configure Enable/Disable Calibration to Brightness , click Save .
Click Manage Coefficients to display the next window.
LED Display Control Setting