Barco IEX Series, Инструкция по установке и эксплуатации

Страница: 28 / 80

R5915190 /01 IEX series 28
4.1 Power-on testing
Actions before you continue
Before performing control setting on the LED display, confirm that each device is connected correctly.
1. Before turning on the power of the LED display, you must use a multimeter to test the live wire, neutral
wire, and ground wire of the AC power supply, in order to ensure they are not conductive with each other.
2. The ground wire must be in reliable contact with the ground and kept away properly from the live wire. The
connected power supply shall be distant from high-power equipment.
3. When the 3-phase and 5-wire system is adopted, the load shall be distributed evenly among the phases to
ensure three-phase balance as far as possible.
4. The input voltage must meet the voltage requirements indicated on the cabinet rating label.
5. Connect the USB cable provided for the sending box to the USB port on the control PC.
6. Check whether cables for the LED display are connected in accordance with the power cable and signal
cable connection diagrams provided for the delivered products.
4.2 Starting the hardware
About hardware start
Start the control PC Windows system.
After the graphics card driver is activated, set graphics card of the control PC to replication mode and confirm
that the green indicator of the sending box is blinking normally (blinking once per second).
Image 4 – 1 Replication mode
4.3 Software Control Setting
4.3.1 Installing the software
About the installation
Open the optical disk provided for the delivered products. Install the LED control software NovaLCT-Mars
stored in the optical disk to the control PC. Then install NovaStudio.
You can follow the software installation wizard to install the software.
4.3.2 Display Configuration
How to start up
1. Run NovaLCT-Mars.
Make sure that Control System on the main window is 1
2. Click the User option and select Advanced Login .
LED Display Control Setting