Barco iCon H600, Руководство пользователя

Страница: 42 / 171

5. Setup
5.4 Setting up the projector address (only if necessary)
What can be done ?
The projector is shipped with projector address set to ”0”
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu
Projector Address
, the following addresses can be programmed :
• Projector address: address defined by the user, may be from 0 to 255
0-9 is used for RCU communication, 0–255 being used for RS232 serial communication.
• Common address : address may be 0 or 1
For more info on addresses see the appendix
How to change the projector’s address ?
1. Press MENU to activate the Tool bar
2. Press → to select the
Installation
3. Press ↓ to Pull down the
Installation
menu
4. Use ↑ or ↓ to select
Projector address
Image 5-7
5. Press ENTER
A dialog box appears on the screen
Image 5-8
6. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.
How to change the common address ?
1. Proceed in the same way as for the projector address
36 R5976821 BARCO ICON 15/03/2007