Barco iCon H250, Руководство пользователя, Страница: 40 / 154

6. Setup
Common address/Projector address : Beside the projector address, the projector disposes also of a Common
address which can be set to “0” or “1” (by default “0”).
In other words, an RCU set to address “0” will always control a projector regardless of its projector address
(since it uses the common address).
6.5 Setting up the projector address (only if necessary)
What can be done ?
The projector is shipped with projector address set to ”0”
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu
Projector Address
, the following addresses can be programmed :
• Projector address: address defined by the user, may be from 0 to 255
0-9 is used for RCU communication, 0–255 being used for RS232 serial communication.
• Common address : address may be 0 or 1
For more info on addresses see the appendix
How to change the projector’s address ?
1. Press MENU to activate the Tool bar
2. Press → to select the
Installation
3. Press ↓ to Pull down the
Installation
menu
4. Use ↑ or ↓ to select
Projector address
Image 6-5
5. Press ENTER
A dialog box appears on the screen
Image 6-6
6. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.
34 R5976992 ICON H250/400 13/12/2006