Barco HDF-W30LP, Руководство пользователя и инструкция по установке

Страница: 133 / 311

13. Input
13.10.5 3D second input
What can be done?
3D content can be entered into the projector via a single channel (one input) or via 2 channels (2 inputs). When entering content via
2 channels, the second source must be indicated in the 3D menu.
This selection is only possible when a 2 channel 3D input is chosen.
How to make selection
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Input → 3D → Second input .
Image 13-37
3D second source
2. Press ENTER to select.
The Source selection window opens.
3. Use the ▲ or ▼ key to select the desired input and press ENTER ..
Image 13-38
Second source, select input
13.10.6 L-R Synchronisation, fi eld dominance
About fi eld dominance
The Field dominance setting has only effect in the 3D mode: Frame sequential - Single channel (in all other modes this setting is
grayed out). Furthermore, the input frequency must be equal or lower than 100 Hz (50 Hz per eye). In case the input frequency is
higher than 100 Hz (50 Hz per eye, 59.94 & 60 Hz in practice), the “Field dominance” setting has no effect.
For the lower input frequencies (40 Hz or lower/eye), triple fl ash is used and for frequencies between 40 and 51 Hz/eye double
fl ashing is introduced and the coupling between the video input signal and the 3D SYNC IN signal must be determined.
This setting is stored per input.
How to activate
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Alignment → 3D Glasses →
L/R Synchronisation .
R5906730 HDF WLP SERIES 01/08/2017 129