Barco HDF W series, Инструкция по использованию и установке

Страница: 168 / 319

12. Alignment
12.7.5 Setting the warping level
How to select
With the Warping menu displayed, use the ▲ or ▼ key to select more or less pixels to adjust.
Switching between the more or less pixels icon can be done with the ◄ or ► key.
1 2
Image 12-37
Warp level selection
1 Increment pixels
2 Decrement pixles
The current selected icon shows blue.
Press ENTER to increment or decrement the number of pixels.
The value inside the icon changes accordingly.
The following selections are possible:
-
2 x 2 (highest level);
- 3 x 3;
- 5 x 5;
- 9 x 9;
- 17 x 17;
- 33 x 33 (lowest level).
12.7.6 Warp adaptation steps
About the steps
An anchor point can be moved with a fi xed number of steps: 1, 10 or 100. It is also possible to move an anchor point with custom
number of steps or a part of a step.
How to select a prede fi ned number of steps
Use the ▲ or ▼ key to go to the Warp adaptation steps area.
The current selection is indicated in yellow.
Use the ◄ or ► key to select the desired steps.
164 R5905158 HDF SERIES 16/06/2015