Barco Galaxy NW R9040406, Руководство пользователя, Страница: 136 / 209

5. Advanced
Overview of Dynacolor sets
Depending on the projector settings, different Dynacolor sets are enabled and/or available:
•
Monoscopic mode: two Dynacolor sets ( Set 1 and Set 2 ) can be selected and adjusted;
• Active stereo mode: two Dynacolor sets ( Set 1 and Set 2 ) can be selected and adjusted;
• Active In fi tec stereo mode: two Dynacolor sets ( In fi tec A and In fi tec B ) can be adjusted. Set A is used for the left-eye images,
while Set B is used for the right-eye images. These sets are automatically selected when the In fi tec fi lter moves into the projector
light path;
• Passive In fi tec stereo mode: one Dynacolor set ( In fi tec A or In fi tec B, depending on the In fi tec fi lter in the projector ) can
be adjusted. This set is automatically selected when the In fi tec fi lter moves into the projector light path.
In the following procedures we will only explain the selection of Set 1 . The same procedure applies for Set 2 .
How to select a Dynacolor set ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Dynacolor
5. Press → to open the menu
6. Use ↑ or ↓ to select Active Set
7. Press → to open the menu
8. Use ↑ or ↓ to select for example Set1
Image 5-150
9. Press ENTER
A white bullet indicates the active setting
5.9.7.3 Enabling DynaColor
Enabling DynaColor can be done by the operator.
What can be done ?
Enabling DynaColor changes the projector’s native color range to the color range as speci fi ed in the active DynaColor set. Disabling
DynaColor will keep the original colors determined by the source and the projector’s optical path.
How to enable Dynacolor?
1. Press MENU to activate the Tool bar
130 R59770718 GALAXY NW SERIES 20/06/2013