Barco Galaxy NW-7, Руководство пользователя

Страница: 37 / 220

4. Installation
'(6.723,1387 '(6.723,1387
535 535 *< *< %3% %3% +V&V +V&V 9V 9V 9,'(2 9,'(2 69,'(2 69,'(2
,1 ,1 ,1 ,1
/ /
67(5(2,1387 67(5(2,1387 67(5(2287387 67(5(2287387
/ / / /
,1 ,1 ,1 ,1 ,1 ,1 ,1 ,1
56& 56& '9, '9, 5& 5&
HUB
To LAN
'9, '9, '9, '9,
Image 4-28
Connection via a hub
See Network settings to set the communication port.
The linking of projectors is treated in the section “Setup of the linked projectors in a multichannel system”
4.5.12.2 Network settings
C
AUTION
:
Make sure that a DHCP server is available in the network and works fi ne.
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto
fi ve minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
What can be done?
These settings are used to set the Ethernet Communication parameters.
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013 33