Barco Galaxy NW-7, Руководство пользователя

Страница: 33 / 220

4. Installation
The desktop can be enabled/disabled, "Desktop", page 129
Using the desktop input makes only sense when using the Barco Desktop integration software. The Desktop
integration software is covered in the Desktop integration User Guide.
4.5.9 DVI output
DVI output
DESKTOP INPUT DESKTOP INPUT
R / PR R / PR
G / Y G / Y
B / PB B / PB
Hs / Cs Hs / Cs
Vs Vs
VIDEO VIDEO S-VIDEO S-VIDEO
DVI DVI
IN1 IN1 IN2 IN2
L1 L1
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
L2 L2 L3 L3
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
COMPUTER COMPUTER
RS 232 C RS 232 C DVI DVI R.C. R.C.
Image 4-23
DVI output
The DVI output is a single link DVI output signal, having the following speci fi cations:
• resolution: is the same as the native resolution of the projector;
• vertical refresh rate: 60 Hz;
• signal type: digital signal (DVI).
It re fl ects the projected image, excluding Geometry corrections, Soft edge and Black level correction, Dynacolor settings and OSD.
C
AUTION
:
If the projector runs in synchronous mode, the DVI output is synchronous with the input signal.
In this mode, most monitors will not display the signal in a correct way!
C
AUTION
:
If the selected input signal is a stereo signal, a black image is displayed at the DVI output.
4.5.10 Stereo connections
What can be done ?
The stereo sources sync signals have to be connected to the 4th layer of the front panel. The stereo input layer holds 6 mini DIN
connectors and 2 BNC connectors.
The 6 mini DIN connectors are the stereo sync input connections for respectively from the left to the right, the 1 st ,2 nd and 3 rd layer.
The order is from left to right eg. for the DVI input board, the left DIN connector (L3/IN1) is for the left connector on the DVI input
board and the right DIN connector (L3/IN2) is for the right connector on the DVI input board.
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013 29