Barco Galaxy NH-12, Руководство по установке опций, Страница: 17 / 35

3. Kit installation (detailed)
Image 3-17
input module:
fi xing front screws
4. Put the preformatter unit next to its correct position and plug in the connectors:
- J100, J101, J102 on the preformatter: data from connectors J823, J824 and J825 on the PMP
- J11on the preformatter: power supply from connector 6 on the power box
- J410 on the PMP: commands from connector J410 on the local keypad
- J13 on the PMP: commands from the IR receiver
5. Use one screw to fi x the three grounding wires to the preformatter
6. Fix the preformatter unit to the input module using four screws
Image 3-18
Preformatter unit: front screws
7. Install the covers (see concerning chapters):
- engine fan cover 1
- top cover
- rear cover
3.3 Restoring the backup
Procedure
Restore the backup using Projector Support tool . For more details, see "Backup and restore data", page 15.
3.4 Upgrade the projector to the desired software version
Introduction
Projector upgrade is done through Ethernet. Prior to starting the procedure below, make sure the Ethernet settings in the OSD are
set to the correct values to make Ethernet communication possible between computer and projector.
R59770498 PMP KIT 28/02/2011 13