![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029087.webp)
FSN Series • User’s Guide
87
3. Control Panel Orientation
Control Panel Rear
6) DVI
Connector
One
DVI
connector is provided to connect the control panel to the
Touch Screen
.
Use
the supplied cable harness for interconnection. In Appendix A, refer to the
“
” section on page 315 for pinout details.
7) CPU
Switch
The
CPU Switch
is located inside the small hole. This switch is designed for
qualified service personnel only.
8) Ethernet
Port
1
One RJ-45 connector is provided for 10/100BaseT
Ethernet
communications.
Port 1 is connects to the
FSN-1400
, either directly or via an Ethernet Switch. By
default, the following conditions are set:
~
DHCP =
OFF
~
Default IP address:
192.168.0.5
~
Default Netmask:
255.255.255.0
The user can use the default address, or set a different address. In Appendix A,
see the “
” section on page 316 for pinouts.
9) Ethernet
Port
2
One RJ-45 connector is provided for 10/100BaseT
Ethernet
communications.
Port 2 can be connected to an outside network, or to your facility’s “house”
network. By default, the following conditions are set:
•
DHCP =
ON
An IP address can be obtained automatically from the outside network. In
Appendix A, see the “
” section on page 316 for pinouts.
10) USB Ports
Four
USB
ports are provided. Use one of the four ports to connect data to the
Touch Screen
, using the supplied cable harness for interconnection. The
remaining ports can be used for connecting customer-supplied USB drives, or if
required, to connect a mouse and keyboard.
11) DC Power Out
One
DC Power Out
connector is provided for the
Touch Screen
power. Use the
supplied cable harness for interconnection.
12) Audio Connectors
The three audio connectors are not supported.
13) Fan
One
Fan
is provided for control panel cooling. To prevent overheating, do not
block the vent.
14) AC Power
One
AC Connector
is provided for connecting the control panel to AC. The
integral switch turns the panel on and off. In Appendix A, refer to the “
” section on page 310 for power details.
Important
Do not use this switch unless instructed to do so by Barco
Customer Service personnel.