![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029069.webp)
FSN Series • User’s Guide
69
3. Control Panel Orientation
Control Panel Descriptions
S
BG
+
WIPE
enabled — press
AUTO TRAN
to wipe from
PGM
to
PST
.
S
DSK
+
MIX
enabled — press
AUTO TRAN
to mix the DSK on or off.
S
BG
+
DSK
+
MIX
enabled — press
AUTO TRAN
to mix from
PGM
to
PST
, and simultaneously mix the DSK on or off.
Press
AUTO TRAN
during
the transition interval to pause the transition. The
Transition LEDS
indicate the point at which the transition is paused. Press
AUTO TRAN
again to continue in the same direction. You can pause and
continue repeatedly.
7) FTB
The
FTB
(Fade to Black) button enables you to transition the switcher’s Program
output to black. Please note:
~
When pressed, the switcher fades to black, including the DSK. Once in
black, the
FTB
button blinks.
~
While in black, the M/E bank is fully functional. Any source can be preset
on any bus, and any memory register can be recalled — but the setups
will not contribute to the switcher’s
Program
output. However, individual
M/E outputs are still functional (e.g.,
M/E 1 Out
).
~
When
FTB
is pressed again, the switcher fades up from black to the
current setup. If the DSK is enabled, it remains enabled.
~
Use the
Transition Menu
to change the FTB transition rate. The current
transition rate appears in the
Transition Display
. In Chapter 5, refer to
the “
” section on page 134 for details
Note
Use the
Transition Menu
to change transition rates and to
select transition curves. Remember that the bank’s transition
rate appears in the
Transition Display
. In Chapter 5, refer to
the “
” section on page 134 for details.
Note
You can use
AUTO TRAN
and the
T-Bar
together. For
example, you can start a transition manually, and continue it
automatically. In Chapter 7, refer to the “
” section on page 285 for full details.
FTB