![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029188.webp)
188
FSN Series • User’s Guide
5. Menu Orientation
System Menu
oÉ~ê=fLl=sáÉï=aÉëÅêáéíáçå
The figure below illustrates a sample
Rear I/O View
on the
Input Menu
:
Figure 5-81.
Input Menu, Rear I/O View (sample)
The
Rear I/O View
shows the I/O panels for FSN-1400 slots
1
through
7
, which can be
used for input cards. This view always matches your system configuration exactly —
based on the installed cards. Please note:
•
The number of each slot is shown along the top.
•
The type of each installed card is shown along the bottom (e.g.,
NIC
,
UIC
).
•
If a card is not installed, the label “
Not Installed
” appears in the slot.
•
To set up a native input, press the desired connector on a
NIC
. The yellow border
indicates that the connector is selected, and in the
Input Table
, the input is
automatically highlighted.
•
To set up a universal input:
~
Press any of the top three connectors to select
Input 1
, or any of the
bottom three connectors to select
Input 2
. The selected input is
highlighted with a yellow border around all three connectors.
~
Next, press the desired connector (either
Analog
,
DVI
or
SDI
) to
highlight it with a green border. This indicates that the connector is
selected, and in the
Input Table
, the input is automatically highlighted.
Please note:
~
When you switch connectors on the
UIC
, freeze will always be turned off.
If “
Black on Invalid Video
” is turned on, the input will go black as it
acquires the new input.
Refer to the “
” section on page 189 for important information about
Rear
I/O View
connectors.
Slot 1
NIC
Slot 2
NIC
Slot 3
UIC
Slot 6
Slot 7
Not
Installed
Not
Installed
Not
Installed
Not
Installed
1
2
8
7
6
4
5
3
1
2
8
7
6
4
5
3
Slot 4
Slot 5
Analog 1
DVI 1
SDI 1
SDI 2
DVI 2
Analog 2
Analog 1
DVI 1
SDI 1