FSN Series • User’s Guide
135
5. Menu Orientation
Transition Menu
qê~åëáíáçå=jÉåì=^ÅÅÉëë
There are two ways to access the
Transition Menu
:
•
In the
Menu Bar
, press
{Page}
to display page
1
(if required). Then, press the
{Trans}
button.
•
Press and hold any
MIX
button on the control panel (e.g.,
MIX
in the M/E 1 bank
or the PGM bank).
qê~åëáíáçå=o~íÉ=^ÇàìëíãÉåí
Transition rates can be adjusted from
1
to
999
frames, in 1 frame increments. There are
two ways to adjust rates individually:
•
Turn the
Knob
adjacent to the any value button to adjust the auto transition rate
(in frames) for that specific location (
M/E 1
,
PGM
or
FTB
).
~
The value on the button changes as you adjust, and the associated
Transition Display
(on the panel) updates.
~
Changes in rates take effect immediately.
•
To “key in” an auto transition rate, press any value button to display the
Keypad
for that specific location. Enter a new rate (in frames) and press
{Enter}
, or trim
the current rate using
{Trim -}
or
{Trim +}
.
You can also enter or trim all transition rates simultaneously:
•
To set all rates to the same value, press
{All/Set Trim}
. All value buttons light.
Next, press any value button to display the keypad.
~
To set all rates to the value in the keypad’s register, press
{Enter}
.
~
To set all rates to a new value, enter the new value and press
{Enter}
.
•
To trim all rates simultaneously as offsets to their current values, press
{All/Set
Trim}
. All value buttons light. There are two ways to trim the value:
~
Turn any
Knob
to increment or decrement all rates.
~
Press any value button to display the keypad. Enter the desired “trim”
value and press
{Trim +}
or
{Trim -}
as desired.
M/E 1
30
All
Set/Trim
