Barco F90 series, Руководство по обслуживанию

Страница: 118 / 141

22. TI Loop
22.2.9.2 Converging Lens (Exit)
In order to access the exit lens, the TI loop must be separated from the illumination engine.
Ensure the TI loop cover is mounted before you release the TI Loop.
1. Release two screws (TX20 m50X45) holding the Dow Tail clamps. This releases the TI loop form the Illumination Engine Front.
2. Release 4 screws (Tx8 M2.5x6) holding the clip and lens.
Image 22-16
Image 22-17
22.2.10 Adjusting Mirror
1. 2. Remove 2 screws (TX8 M2, 6x6).
2. 2. Pull clips in the direction of the red arrow using a sharp implement (e.g. tip of scalpel) and replace Mirror blue.
Image 22-18
Image 22-19
22.3 TI Loop Right
You may need to use a screw driver or similar to gently bend loose the light path from the remaining optical
engine.
Most components inside TI Loop right are mounted following same procedure as documented for left loop.
Exceptions are documented in the following chapter.
116 723–0016 F90 01/12/2017