Barco F400, Руководство пользователя

Страница: 35 / 220

35 R5915525 /00 Fx400 Series
Nr Name
Description
1 12V DC 12 V output, maximum 1A available when projector in not in standby
2 Trigger out 12 V DC, 0.5A (6W) for controlling peripherals like motorized screens, curtains etc.
Give 12V output when projector is switched on. See also note below this table.
3 Wired remote Connect the RCU via a mini jack 3,5 mm with the wired remote input to control the
projector without interference.
4 LAN Standard RJ45 connector for projector control
5 USB 2 USB 2.0 type A for software upgrade or downloading log files without a network
connection.
6 HDMI Standard HDMI 2.1 for source connection to the projector.
7 DP Standard Display Port (1.4), for source connection to the projector.
8 Sync I/O BNC sync port in/out for projector control. This is mainly used in multiple projector
installations with requirement of synchronization between the units.
9 Input board Quad DP 1.2 input board.
Regarding the Trigger Output: If these outputs are loaded too heavy, there is a risk that the projector
will go in reset mode, and restart. This causes no damage to the projector, but is an undesirable
response. This will also happen if the startup current for the external equipment is too high, even
though the nominal power consumption is less than 0,5A.
3.4 Making connections
Source signal connectivity
The connection panel at the back of the projector is used for all source connections.
Source signal connectivity on the projector:
• 1 x DP 1.4 (HDCP 2.2)
• 1 x HDMI 2.1 (HDCP 2.2)
• 4 x DP 1.2
About HDCP
HDCP protocol is a form of digital copy protection to prevent copying of digital audio & video content as it
travels across connections.
Capability of a connector to accept HDCP content (revision v1.X or v2.X) can vary and depends of the FPGA
resource mapping that manage connectors. Please refer to the Home/Source menu to obtain this information.
3.5 Control interface
LAN
Parameter Value
Ethernet connector 1x RJ45 connector for projector control
Protocols DHCP, TCP/IP, UDP/P
Speed 10/100/1000 Mbit
Input & Communication