Barco F400, Руководство пользователя

Страница: 26 / 220

R5915525 /00 Fx400 Series 26
Tip: Use alkaline batteries for optimum range and lifetime.
+
-
-
+
Image 2–3
3. Insert (1) both lower tabs of the battery cover in the gaps at the bottom of the remote control, and press (2)
the cover until it clicks in place.
+
-
-
+
1
2
Image 2–4
When replacing batteries, the broadcast address of the RCU will be reset to its default value '0'.
CAUTION: Replace with the correct battery type. Use two AA size batteries. There is a risk of
explosion if the battery is replaced with an incorrect type.
CAUTION: Replace the battery as explained above. There is a risk of explosion if the battery is
incorrectly installed.
2.3 Pulse RCU, protocol setup
Pulse Remote Control Units produced from April 2023 onwards will only support the NEC protocol.
There will no longer be a switch in the battery compartment to select the legacy RC5 protocol.
About the used protocol
The protocol is the code send out by the remote control when a button is pressed. Depending on this code, the
projector can decode the signals. The remote control can be used with two different protocols: RC5 and NEC.
Depending on the projector, the remote control can be switched between these protocols.
Which protocol to use
• The NEC protocol must be used for Barco projectors based on the Pulse platform: F70, F80, F90, HDX 4K,
UDX, UDM, XDL, F40, F400, etc.
• The RC5 protocol must be used with all legacy Barco projectors: HDQ 2k40, HDF, HDX W, etc. (legacy
products)
Remote Control Unit