Barco Event Master E2 Series, Руководство пользователя

Страница: 282 / 584

R5905948 /12 Event Master Devices 282
3. Select EDID format (for DVI, HDMI and DisplayPort inputs). Select EDID from the drop-down list, then select
frame rate from the drop-down list and finally select Apply.
4. Apply specific EDID parameters based on a standard EDID. VESA calculator needs to be used.
5. If several connectors should have the same EDID, check the Apply to all Backgrounds checkbox before Apply
and Save.
6. Select HDCP mode (for DVI, HDMI and DisplayPort inputs).
7. Select color space, capacity and type (for SDI inputs).
8. Perform color adjustments.
9. Read all timing parameters associated with the selected format.
Add Multiple Inputs
Use this feature to select more than one input connector to create an individual input for each connector
selected. This is a shortcut, like the "
Auto add... " buttons, but it is limited to only the selected connectors.
(Optional) Delete Inputs
1. Click on the blue button Delete Input(s) .
2. From the Name list click on the “ x ” space next to the Input(s) you wish to delete. Or select connectors.
3. Hit the red Delete Selected button. All of the selected Inputs will be removed from the list.
(Optional) Edit the Name
1. Double click on default name in the Name list to edit the name.
2. When the area turns blue, click the eraser icon to clear the field.
3. Type a new name.
Note: It is recommended to name inputs based on the actual connection scenario instead of the
connected devices function. This is due to several layers of naming that can be done in the system to
simplify understanding during operation.
7.13 Configuration Menu > Add Outputs
General
In this procedure, you will add Outputs to the system .
Prerequisite
• Ensure that you are familiar with the Configuration Menu . For details on this menu, please refer to
chapter “ Configuration Menu ” , page 109
If more than one Output is required, repeat the below steps until all outputs are added and adjusted.
Connector Capacity
Each connector has a capacity setting that assigns internal resources to the connector. In order to increase
the capacity of an individual connector, you may first have to reduce, or disable capacity from other
connectors on the same card. For example, if two Dual Link signals are required to be output on a HDMI 1.4
output card, the capacity of the two bottom connectors must first be set to "None."
If a connector is to be used to accommodate a 4K signal all other connectors on each card needs to be set to
“ NONE. ”
3G-SDI Outputs can only output UHD/4K over a Quad connection.
System Setup