Barco Event Master E2 Lite, Руководство пользователя

Страница: 186 / 330

R5909934 /00 E2 Lite and EC-40 186
7.16 Configuration Menu > Add MVR Outputs
General
In this procedure, you will add MVR Outputs to the system.
Prerequisite
• Ensure that you are familiar with the Configuration Menu . For details on this menu, please refer to
chapter “ Configuration Menu ” , page 71
Add MVR Output
1. Click on the MVR tab to select the outputs that will be defined.
Auto create MVR Outputs
Auto create MVR Outputs is pressed to create the two available MVR outputs.
The MVROut1 and 2 have a Unit ID, which is the same as the actual unit, it is there to allow
selection in linked scenarios.
(Optional) Edit the Name
1. Double click on default name in the Name list to edit the name.
2. When the area turns blue, click the eraser icon to clear the field.
3. Type a new name and hit enter when done.
(Optional) Adjust Output Parameters
Click on the Adjust tab that is located on the top. The output adjustment panel is divided in three sections
(Main, Timing, Connector). In the Adjustment panel you can:
1. [Main tab] Auto Configure Output Format function is not available for MVR at this time.
2. [Main tab] Edit the name.
3. [Main tab] Select Format value and Frame Rate.
4. [Main tab] Enable Test Patterns with raster box and enable diagonal motion.
5. [Timing tab] Read all timing parameters associated with the selected format and make adjustments.
Adjustments are limited to the formats that can be pre-selected.
6. [Connector tab] Select HDMI Sync standards.
7. [Connector tab] Select Color space and Sample bit depth available as reported from the EDID of the Device.
8. [Connector tab] Select HDCP Mode for Multiviewer outputs.
The default for HDCP Mode is Off. To turn On the HDCP Mode, click on the empty HDCP Mode checkbox.
When the checkbox displays a check mark, HDCP Mode is On. HDCP Mode is not applicable to SDI outputs.
System Setup