Barco DP2K SLP Series, Руководство пользователя и инструкция по установке

Страница: 20 / 175

2. Getting started
2.1 Installation requirements
Environmental conditions
The table below summarizes the physical environment in which the DP2K SLP-series projector may be safely operated or stored.
Environment Operating Non-Operating
Ambient Temperature 10°C (50°F) to 35°C (95°F) -15°C (5°F) to 60°C (140°F)
Air cleanliness Clean of fi ce environment (equivalent with clean room
standard ISO 14644-1 ISO Class 9)
n.a.
Humidity 5% to 85% RH Non-condensed 5% to 95% RH Non-Condensed
Altitude -60 (-197 Ft) to 3000 m (9843 Ft) -60 (-197 Ft) to 10000 m (32810 Ft)
Let the projector acclimatize after unpacking. Neglecting this may result in a startup failure of the Light Pro-
cessor Unit.
Use in high altitude conditions
When 3000 m environmental condition is combined with the highest permissible temperature (35°C ambient), the projector may be
expected to go into warning status. Hence, for high altitude conditions, we advise max 30°C ambient condition (25°C is preferred).
Furthermore, to avoid temperature warnings on laser banks, we advise in high altitude to set cooler fans to 100%.
Main Power requirements
The DP2K SLP-series projector operates from a nominal mono phase power net with a separate earth ground PE.
Projector Power requirements
DP2K-10SLP 200-240 VAC, 50-60 Hz, 10 A at 200 VAC
DP2K-8SLP 200-240 VAC, 50-60 Hz, 10 A at 200 VAC
The power cord required to connect the projector with the power net is not delivered with the projector. It is the responsibility of the
customer to provide the correct type of power cord. The cross-sectional area of the conductors in the power supply cord shall not
be less than
2.5 mm 2 (12 AWG) , minimum 300 V. Take into account that the cable gland allows a cable diameter from 8 to 13 mm.
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that the instrument panel
and cabinet be grounded. In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a quali fi ed electrician in conformance to local codes. Hardware, wire sizes and conduit types
must comply with local codes.
A readily accessible disconnect device shall be incorporated externally to the equipment for removal of the power to the equipment
mains terminals.
W
ARNING
:
Disconnect the power to the unit mains terminals for removal of all power from the unit.
The DP2K SLP-series projector does not have a built in UPS unit.
Projector weight
Do not underestimate the weight of the DP2K SLP-series projector. The projector weight approximately 73 kg (161 lb.) without lens.
Ensure that the pedestal on which the projector is installed is capable of supporting the complete load of the system. Minimum 4
adult persons are needed to carry the projector.
Barco offers a pedestal for the DP2K SLP-series projector. This universal pedestal allows for a solid and
easy setup of the projector. The universal pedestal support 19” rack systems. (projector peripherals such as
alternative content switchers, ShowVault, etc.)
16 R5906847 DP2K SLP SERIES 02/06/2017