Barco DP2K-19B, Руководство по установке

Страница: 19 / 125

2. General
1
2
Image 2-4
Remove wooden pallet
5. Take the projector from the wooden board by gripping the bottom of the projector and place the projector on the pedestal.
Image 2-5
Remove projector
2.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found,
fi le claim with carrier immediately. The Barco Sales and Service of fi ce should be noti fi ed as soon as possible.
The packaging of the B-series projector is provided with a shock-watch label. If this shock-watch label was
triggered (red colored at arrival) during transport, indicates that the package was possibly roughly handled by
the transport company. In this case, the instructions mentioned on the label, should be followed, which are:
adding a note on the “bill of lading” and informing the transport company and the Barco sales and service
of
fi ce as soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items where included:
• One short power link cable (mono phase) (in case no UPS is used) - Installed on projector.
• This manual (installation manual).
• CD
• Safety manual
The projector lens and xenon lamp are not included in the package of the projector.
R5905067 DPXK-19B/23B/P 17/09/2012 13