Barco DP2K-12C, Руководство по обслуживанию

Страница: 289 / 359

17. Lamp power supply
17.2 LPS diagnostic LED’s
Status LED’s on LPS unit
The LPS module contains in total 8 status LEDs. Four orange, three green and one red LED.
The orange LED “LVPS OK” lights up immediately after the projector is switched on. At the same time, the heartbeat LED starts
blinking. All other status LEDs of the LPS unit remain off. This is the standby status of the LPS unit. Once the command is sent
to the LPS units to start up the projection lamp, the green LEDs are lighting up one after the other. First the green LED “PFC OK”,
then the green LED “LPS OK” and
fi nally, when the lamp is ignited, the green LED “LAMP ON”. The right orange of the upper row
blinks. This is the heartbeat signal
The red LED “ERR” remains off unless an error is detected inside the LPS unit or when the LPS unit are ordered to shutdown due
to a malfunction somewhere else inside the projector.
LAMP ON / LVPS OK
ERR PFC
OK
LPS
OK
Image 17-2
LED indications
Diagnostic
About the orange LEDs next to the CTRL connectors:
ERR PFC
OK
LPS
OK
A B C
Image 17-3
LED A and B are only for internal use. LED C is the heartbeat LED.
Orange LED C Diagnostics Action
Blinking Normal operation
-
OFF 12 V from backplane via CTRL IN not available on LPS
unit Check 12V out on backplane.
ON 12 V from backplane available. Replace the LPS module.
About the diagnostic LEDs, ERR, PFC, LPS, Lamp ON and LVPS.
Orange Green Green Grreen Red
LVPS OK PFC OK LPS OK LAMP OK ERR
Diagnostic Action
OFF OFF OFF OFF OFF No input voltage. Switch on the projector.
ON OFF OFF OFF OFF Standby modus of LPS unit.
—
R5905043 DP2K-12C/11CX 19/02/2018 285