Barco DML-1200, Руководство пользователя

Страница: 34 / 113

6. Input menu
An auto alignment of the current source is executed.
Image 6-3
Image 6-4
Image 6-5
6.3 Reset to factory presets
What can be done ?
All internally created image fi les due to switching from source or using the auto image alignment function can be cleared by a reset
to factory presets.
Do not use this function during a show as it can delete previous created information necessary for the show.
Use this function before the set up of a show.
How to reset
1. Press Enter to start up the main menu.
2. Turn the jog dial to select Input and press Enter .
The input selection menu opens.
3. Turn the jog dial until the second page of the input menu is displayed and turn further to select Reset to factory presets and press
Enter .
A reset is executed.
Image 6-6
Image 6-7
Image 6-8
6.4 Image load mode
What can be done ?
When the image lock mode is set to Auto , image fi les can be created and saved.
When the image lock mode is set to Locked , the current image fi les are immediately saved and locked. No new image fi les can be
created or loaded. Settings can be changed during the show but are not saved. When reconnecting the source, the original settings
are restored again.
When the source changes in lock mode, in some cases, the projected image can change, can distort or can fully disappear. Once
the original source is restored, the projected image returns with the original settings.
Example : the lock mode is set to Auto while setting up the show. Once the setup is fi nished the lock mode is set to Locked so that
the show always starts with the original settings.
30 R59770208 DML-1200 06/11/2009