86
DCS-200 • User’s Guide
4. Operation
Using Inputs
råÇÉêëí~åÇáåÖ=^ìíç=^ÅèìáêÉ
Please note the following important points regarding the
In Auto Acquire
mode:
•
If
In Auto Acquire
is
ON
and a valid input is selected that does
not
have a saved
Input Config File
associated with it, the system attempts to acquire the source
and save an
Input Config
file. This process
may
take a few moments.
•
If an input is selected that
does
have a saved
Input Config File
associated with it,
the (blinking) source will transition to program after
TAKE
is pressed.
•
When the system performs an
Auto Acquire
for
Inputs 7
or
8
, the DCS-200 first
checks for a DVI signal. If not found, the system looks for a valid analog signal.
•
If
In Auto Acquire
is
OFF
and a valid input is selected (either with or without a
saved
Input Config
file), the system compares the library file to the input’s
incoming timing.
~
If the timings match, the system transitions to the input after
TAKE
is
pressed.
~
If the timings do not match, the “
Invalid Signal
” message appears, and
the system transitions to black after
TAKE
is pressed.
rëáåÖ=ea`m
With DCS-200, the HDCP mode is essentially automatic. Provided that you connect an
HDCP compliant monitor, you can select and switch between unprotected sources and
“protected” HDCP sources (e.g., a Blu-Ray player) without restriction.
•
Inputs
1
-
6
(analog) are unprotected sources.
•
Inputs
7
and
8
(analog) are unprotected sources.
•
Inputs
7
and
8
(digital) are protected when an HDCP source is connected.
Please note the following important points regarding HDCP operations:
•
When the input signal is an HDCP source on DVI inputs
7
or
8
, the following
message appears if a non HDCP-compliant monitor is connected:
Figure 4-61.
Error Message: HDCP Not Supported
Note
The
Input Config
file will only be saved if the "
Auto Input
Save
" mode is
ON
in the
User Preference Menu
.
Note
As a prerequisite, ensure that you have read the “
” section in Chapter 1 on page 17 prior to
reading this section.
S e l e c t i o n N o t A l l o w e d
O u t p u t D i s p l a y d o e s
n o t s u p p o r t H D C P
Содержание DCS-200
Страница 1: ...r d a pJOMM Manual 26 0604010 00 Revision 00...
Страница 114: ...114 DCS 200 User s Guide 6 Upgrading Software Ethernet Upgrade Method...
Страница 126: ...126 DCS 200 User s Guide K p Format Table...
Страница 158: ...158 DCS 200 User s Guide _K o Remote Commands...
