Barco CX-50 Gen2, Руководство по установке

Страница: 78 / 144

R5900120 /01 CX-50 Gen2 78
6.7 Display setup, Outputs
Display port
Display port output via USB Type C TM port at the back side of the Base Unit.
This output is enabled by default and the resolution is fixed set to Auto .
HDMI
When there is an HDMI connection between the Base Unit and a display, the display type is indicated. The
resolution can be selected.
Resolution
The output resolution to the display is set on Auto. That means that the CX-50 Gen2 output resolution is
automatically adapted to the resolution of the display. For HDMI displays, a hot plug detection is available.
When a display is connected to the output the Model & Vendor or indicated.
When no display is connected, the indication Not Connected is displayed next to Model & Vendor .
Display mode
The display mode can be set to extended or clone. When set to clone, exactly the same as in the connected
device is shown. When extended, an extra window can be shown.
CEC
Consumer Electronics Control (CEC) is a feature of HDMI designed to allow users to command and control
devices connected through HDMI by using only one remote control.
To enable CEC, check the check box before Enable CEC .
Audio output
Audio can be enabled by checking the check box before Enable audio .
When an USB speakerphone is connected to your device, this device will be the default audio output device
for both conference and content audio an it will not be possible to configure HDMI, DP or audio jack as audio
output. USB is by default selected and cannot be changed.
When no USB speakerphone is connected with your device, you can configure the audio output and select
HDMI or DP or audio jack.
The UI illustration image shows a device with USB speakerphone connected.
Since all audio is played out and captured from the echo-cancelling speaker, the peripheral will
cancel out the content audio. Users will have to enable audio sharing into the call when playing
content with audio. This can be selected in the different tools when sharing.
1. Log in to the Configurator .
2. Click Display & Audio → Outputs .
CX-50 Gen2 Configurator