Barco CRPN-52B, Руководство пользователя

Страница: 34 / 90

CR series
User Manual - Advanced setup
english
34
6.8.2 Using DPMS (Display Power Management Signaling)
The projector is enabled for DPMS (Display Power Management Signaling). When enabled,
the projector will automatically switch to standby mode after a specified time if there is no
valid source present at its inputs. When a valid source is reconnected, the projector will start
up again.
To enable or disable DPMS, go to menu entry SETTINGS > DPMS. The desired DPMS time-
out is set in the DPMS > DPMS TIMEOUT menu entry.
DPMS is disabled by default.
6.9 Disabling LED indicators
In certain installations it may desirable to completely disable the LED indicator in the keypad
of the projector. To disable the LED indicators, go to menu entry SETTINGS > LED
INDICATORS MUTE.
If the LED indicators are enabled, the timeout period can be set in the menu under SET-
TINGS > BACKLIGHT TIMEOUT.
6.10 Setting the background color
The background color displayed when the projector is searching for a source can be set to
a set of predefined colors. Go to menu entry SETTINGS > BACKGROUND to set the desired
color. Default is black. Setting OSD menu timeout
If the OSD menu is open and not used for a defined period of time, it will automatically be
disabled. The default time is 30 seconds. This timeout interval can be controlled from 5 sec-
onds to 60 seconds. The timeout can also be set to “never” for the OSD menu to never time
out. Go to menu entry SETTINGS > MENU TIMEOUT to change this setting.
6.11 Selecting the startup logo
When the projector is starting up, a logo is displayed in the entire image. The logo can also
be set to “black” if it is desirable to disable the manufacturers default logo. Go to menu entry
SETTINGS > SPLASH to change this setting.
6.12 Setting OSD menu timeout
If the OSD menu is open and not used for a defined period of time, it will automatically be
disabled. The default time is 30 seconds. This timeout interval can be controlled from 5 sec-
onds to 60 seconds. The timeout can also be set to “never” for the OSD menu to never time
out. Go to menu entry SETTINGS > MENU TIMEOUT to change this setting.
6.13 Selecting the startup logo
When the projector is starting up, a logo is displayed in the entire image. The logo can also
be set to “black” if it is desirable to disable the manufacturers default logo. Go to menu entry
SETTINGS > SPLASH to change this setting.