Barco ClickShare CSE-200, Руководство по установке

Страница: 72 / 85

6. CSE-200 Configurator
How to enable update over Wi-Fi
1. Log in to the Con fi gurator .
2. Click System → Buttons .
3. Check the check box in front of Update Buttons over Wi-Fi .
6.27 Firmware Update
About Software update
The software of the Base Unit can be updated via the web interface. The latest version of the software is available on Barco’s
website.
Image 6-44
Firmware update
About automatic fi rmware updates
Automatic fi rmware updates can be triggered in 3 ways:
• triggered via a scheduled time
• triggered at boot
• manual trigger
How to start an Automatic fi rmware update
1. Log in to the Con fi gurator .
2. Click Support & Updates → Firmware .
3. To check immediately if new software versions are available, click on Check now for updates .
The system checks if new fi rmware is available and uploads this automatically to the Base Unit.
4. To ask a con fi rmation before installing the software update, check the check box in front of Ask con fi rmation... .
5. To check for new software at boot, check the check box Check at boot .
During booting up, when new fi rmware is found, this fi rmware will be loaded and the Base Unit will reboot.
6. To use a schedule, check the check box in front of Check on schedule .
Click on the drop down box and select the desired time slot.
Note: Select a time slot where you are sure the Base Unit will not be in use.
60 R5900023 CLICKSHARE CSE-200 13/07/2016