Barco Balder Series, Руководство пользователя

Страница: 22 / 54

601 – 0443 /03 Balder 22
Toggle between the two indications by using the Menu button on the keypad, or on the remote control
1.
When mirroring the OSD, the LCD showing the menus and adjustment information.
2.
When in information mode, showing this Information regarding the status of the projector:
• Projector status
• Network address and status
• Active source
• Illumination Status
• Current firmware version
• Active functions (Enabled Functions).
• Display Info, including Transport delay
• Environment Info.
Use the navigation keys (arrows) to scroll the information menu.
When in information mode, press OK (confirm selection ( ✓ )) to see notifications and warnings.
The LCD Display will fade out 15 seconds after the last key operation.
2.6 LCD functionality in Ready Mode
When the projector is in Ready mode, it is possible to activate and navigate in the projectors menu on the LCD
display, in order to set or check values and settings before the lamp is switched on.
Ready mode is enabled either when the power cable is connected (after the startup sequence), or when
pressing the Power Off for 3 seconds when the projector is in On mode. See chapter 5.4 Power Mode
Transitions for a graphic presentation of the ready mode.
Procedure
When in ready mode, press the Menu button either on the remote control, or the keypad to enter the menus.
Navigate by using the arrow and OK keys, either on the remote control or the keypad.
2.7 Local keypad
About
The Keypad gives direct access to several functions, in addition to access to the menu system. The keypad
and remote control functions are equal.
The keypad has a back light that can be switched on and off manually. The light turns off automatically after a
preset time.
The Standby key is equipped with white, blue and red backlight depending on the status of the projector. See
table in
“ Power on / Standby button backlight indications ” , page 21 for info regarding this.
Getting to know the projector.