Barco B-16 Mobile LED, Руководство по установке

Страница: 35 / 67

3. Installation
3.6 Assembling third part on the fi rst two
How to assemble
1. Lift up the mast until the half of the red marker is visible.
2. Pull out the sequence pin for 50% (just until the line on the pin is visible).
Tip: If there is too much resistance, move down the mast a little.
Image 3-17
Sequence pin, half out
3. Left up the mast until the safety hole becomes completely accessible.
Note: Due to friction inside the mast, it is possible that hole is not accessible. Lower down the mast again and retry.
Caution: When the cables are already connected to the tiles it is possible the tension on the cables will be too big when you
lift the display more than necessary.
The assembled display parts will be much higher then the third part of the display.
4. Insert the second safety pin and turn a quarter.
This safety pin is placed to work in a secured area while moving the trolley.
5. Unlock both fl oor locks of the trolley.
6. Slide the trolley forward and secure both sides into the third hole.
Caution: Pay attention to the location of the cables so that the wheels of the trolley not override these cables (severe damage
to the cables is possible).
7. open the locks of the tiles.
8. Remove the safety pin again and move down the mast until the assembly fi ts exactly on part 3.
Note: Do not lower down too much.
9. Close the tile locks.
10.Plug in the power and data cables if not yet done.
R59770490 B-16 MOBILE LED 07/01/2010 31