R5976255
A
TLAS
CS4 (2001-03)
5-10
5.1.8 Input Connections
A
TLAS
CS4 has multiple input connections for all common RGB and video sources. The input can
be selected either manually or automatically. When
'automatic'
is selected in the
Input slots menu,
by starting up the projector, it searches for an input source by scanning the inputs one by one. If
only one source is found, this source will be projected. If different sources are found, the priority is
as follows
input facilities
priority of automatic input selection
Video
1
S-Video
2
5-cable input
3
Computer
4
Serial digital input
never automatically selected
IEEE 1394 (not yet active)
never automatically selected
When a RCVDS is connected to the projector, the '
Automatic
' selection is disabled.
5.1.9 Set up of the input selection:
!
Press
ENTER
to start up the adjustment mode.
!
Press the cursor key
up
or
down
to select
'Installation'
.
!
Press
ENTER
to display the
Installation menu
.
!
Press the cursor key
up
or
down
to select
'Input Slots'
.
!
Press
ENTER
to display the
Input slots menu
.
In the Input slots menu the available input sources are marked with
x
!
Press the cursor key
up
or
down
to select
'Input Slots'
.
!
Press
ENTER
to toggle between [
Manual
] or [
Automatic
].
!
Press
EXIT
several times to leave the adjustment mode.
Use of a RCVDS05 or VS05 :
When using a RCVDS05, it is recommended to use a 5-cable output module in the
RCVDS. The outputs of this module have to be connected to the 5 cable input
(slot 1) of the projector.
To switch the projector in the 5-cable mode see chapter
