barbas Unilux-7 45, Руководство по установке и обслуживанию

Страница: 31 / 52

1. Identify the positions where the fitting boxes of the ventilation air inlet and the
ventilation air outlet must be put. Refer to chapter
6.1.2
for requirements on the size
of the ventilation air openings.
2. If applicable, identify the positions where the fitting boxes of the convection air outlets
must be put. Refer to chapter 6.1.2 for requirements on minimum distances from
ceiling and neighboring wall.
3. Build the brickwork around the appliance up to the upper frame around the glass.
4. Install the fitting boxes of the ventilation air inlets.
5. If applicable, install a mantle iron to support the brickwork above the appliance. Put
the mantle iron on both sides of the brickwork. Maintain a space of at least 3 mm
between the appliance and the mantle iron.
6. Build the fireplace around the appliance.
a) Install the fitting boxes of the ventilation air outlets.
b) If applicable, install the fitting boxes of the convection air outlets
7. If applicable, install the decorative frame on the appliance.
6.3.8 Final check on the appliance
Caution:
Wait 4 weeks after the installation before you use the appliance. The cement
used for the fireplace needs to harden and to avoid damage to the plaster
work.
1. Make sure the door closes and opens easy.
2. Make sure the control lever moves easy to left and right without undue noise.
3. Make sure all ceramic plates and the baffles are in the correct position.
Contact your dealer if the final check shows a defect.
Installation
Unilux-7 75 31