10
EN
level of water it contains (fig. 27).
Before the indicator protrudes from the cup tray, the drip tray
must be emptied and cleaned.
To remove the tray:
1. Open the service door (fig. 16).
2. Remove the drip tray and the waste coffee container (fig.
17).
3. Clean the drip tray and waste coffee container (A4).
4. 4. Replace the drip tray and waste coffee container (A4).
5. Close the service door.
Cleaning the water tank
1. Clean the water tank (A12) regularly (about once a month)
with a damp cloth and a little mild washing up liquid.
2. Remove all traces of washing up liquid.
Cleaning the spouts
1. Clean the nozzles periodically using a sponge (fig. 28).
2. Check regularly that the holes in the coffee spout are not
blocked.
If necessary, remove coffee deposits with a toothpick (fig.
26).
Cleaning the pre-ground coffee funnel
• Check regularly (about once a month) that the pre-ground
coffee funnel is not blocked (fig. 21).
Danger!
Before performing any cleaning operations,
the machine must be turned off by pressing the main switch
(A23) and unplugged from the mains power supply.
Never immerse the coffee maker in water.
Cleaning the inside of the coffee maker
1. Check regularly (about once a week) that the inside of the
appliance is not dirty.
If necessary, remove coffee deposits with a sponge.
2. Remove the residues with a vacuum cleaner (fig. 29).
Cleaning the brewing unit
The brewing unit must be cleaned at least once a month.
Important!
The brewing unit (A5) must not be remo-
ved when the appliance is on.
Do not use force to remove the brewing unit.
1. Make sure the machine is correctly turned off (see “Turning
the appliance off”).
2. Open the service door (fig. 16).
3. Remove the drip tray and waste coffee container (fig. 17);
4. Press the two red release buttons inwards and at the same
time pull the brewing unit outwards (fig. 30).
Important!
Do not use washing up liquid to clean the
brewing unit. It would remove the lubricant applied to the inside
of the piston.
5. Soak the brewing unit in water for about 5 minutes, then
rinse.
6. After cleaning, replace the brewing unit (A5) by sliding it
onto the internal support and pin at the bottom, then push
the PUSH symbol fully in until it clicks into place.
N.B.:
If the brewing unit is difficult to insert, you must
first adapt it to the right dimensions by pressing it forcefully
from the bottom and top as shown in the figure.
7. Once inserted, make sure the two red buttons have snap-
ped out.
8. Replace the drip tray and waste coffee container.
Support
Pin
