If you are using the gun with cleaning or disinfection agents, rinse the gun before and after use and prior to longer periods of inactivity (as
from 1 hour). To do so, actuate the spray gun and rinse it thoroughly with clear water to clean the internal parts of the gun.
Maintenance
Important safety instructions!
Assembly, maintenance and repair work may only be carried out by persons trained in maintenance and repair work on wet jet systems and
high-pressure systems. Use only spare parts approved by Suttner GmbH. Only use components (hoses, connectors, etc.) approved for the
respective pressure and temperature range.
Every year, check that the spray gun is safe to use. Arrange to have any defects immediately rectified by an expert.
Are the markings and inscriptions legible?
Does the spray gun close automatically?
Does the safety latch work?
Does the spray gun show signs of mechanical damage?
After max. 1000 operating hours
or a year or if hot water (exceeding 90°C) and chemicals are used after 500 operating hours or 6 months:
Check valve parts (seal seat, O-rings, support rings, ball, piston rod, pressure piece) for damage and if necessary replace completely with a
Suttner repair kit.
After max. 3000 operating hours
or 3 years or if hot water (exceeding 90°C) and chemicals are used after 1500 operating hours or 18 months:
Replace valve parts (seal seat, O-rings, support rings, ball, piston rod, pressure piece) completely with a Suttner repair kit.
Disposal
Please dispose of old equipment in an environmentally friendly manner.
Old equipment contains valuable recyclable materials which should be salvaged for recycling. Please therefore dispose of old equipment at
suitable collection points.
Manufacturer
BAR Group Pty Ltd
15 Hudson Place
Mulgrave, NSW
Australia
Tel. +61 2 4577 2144
e-mail: [email protected]
