Baofeng UV-5R Step-by-Step Programming Guide
Also applies to UV-5RA, UV-5X3, UV-5RAX, GT-3, BF-F8, BF-F9
Noji Ratzlaff
Set the radio to communicate with a repeater at 146.780– MHz, 100.0 Hz
0.
Turn on the radio and make sure it’s unlocked
1.
VFO/M R (frequency mode)
2.
Select the upper display
A/B
3.
Set the frequency
1 - 4 - 6 - 7 - 8 - 0
4.
Set the repeater offset
M ENU - 26 - M ENU - 000600 - M ENU - EXIT
5.
Set the repeater shift direction (SFT-D)
M ENU - 25 - M ENU - (m inus) - M ENU - EXIT
6.
Set the transm it tone frequency (T-CTCS)
M ENU - 13 - M ENU - 1000 - M ENU - EXIT
7.
Set the transm it pow er level
M ENU - 2 - M ENU - HIGH - M ENU - EXIT
8.
Optional: turn off the TDR (I w ould, at first)
M ENU - 7 - M ENU - OFF - M ENU - EXIT
Your radio is now set to transm it as specified
Store the current repeater and tone settings in a memory channel
0.
Follow the procedure above to set your radio
for the frequency of your choice
1.
Clear target mem ory channel 36
M ENU - 28 - M ENU - 36 - M ENU - EXIT
Hear “delete channel”
2.
Store the frequency in channel 36
M ENU - 27 - M ENU - 36 - M ENU - EXIT
Hear “receiving mem ory”
press
%
M ENU - M ENU - M ENU - EXIT
Hear “transm itting mem ory”
press
%
Now stored in m em ory channel 36
Recall a stored memory setting
1.
Press VFO/M R (channel mode)
2.
Press the up or dow n arrow s or enter the
three-digit channel num ber (all three digits)
0 - 3 - 6
The stored channel is now ready for use
