To Address = IP address of the sensor
Figure 336.
MultiHop
tab: IP address of the VE is entered here
13.5.2 Inputs to the Sensor (Outputs from the PLC)
The registers below are used by the PLC to push values to the VE Series camera. MSG (message) commands are used to write (N14) to
the sensor.
Table 20: PCCC PLC Output Registers (Sensor Inputs, N14 Table on the Sensor)
WORD #
WORD NAME
DATA TYPE
0
Input Bits Register (see
on page 190)
16-bit integer
1-2
Product Change Number
32-bit integer
3-5
reserved
16-bit Integer
6-7
FTP Filename String Length
32-bit Integer
8-33
FTP Filename String
String (52 characters)
34-500
reserved
32-bit integer
13.5.3 Outputs from the Sensor (Inputs to the PLC)
The registers below are used to send output values from the VE Series camera to the PLC. MSG (message) commands are used to read
(N7) from the sensor.
Table 21: PCCC PLC Input Registers (Sensor Outputs, N7 Table on the Sensor)
WORD #
WORD NAME
DATA TYPE
0
Input Bits ACK Register (see
on page 190)
16-bit integer
1
Output Bits Register (see
on page 190)
16-bit integer
2-3
Error Code
32-bit integer
4-5
Inspection
Number
32-bit integer
6-7
Iteration
Count
32-bit integer
VE Series Smart Camera
www.bannerengineering.com - Tel: 763.544.3164
189
