Banner T30RW, Инструкция по эксплуатации

Страница: 25 / 43

June 23, 2023
T30RW R-GAGE Washdown Radar Sensor Instruction Manual
25
Reset the Sensor to Factory Defaults
Reset the sensor to factory default settings using one of two methods.
NOTE: If a factory reset is performed through the Banner Radar Configuration Software, the remote input
wire becomes disabled (factory default setting). If the sensor is returned to factory defaults by using the
remote input wire, the input wire remains enabled and the rest of the settings are restored to factory
defaults.
To reset using the Banner Radar Configuration software, go to Sensor › Factory Reset. The sensor indicators flash once, the
sensor is reset back to the factory default settings, and a confirmation message displays.
To reset using the remote input, eight-pulse the remote input to apply the factory defaults.
T
T
T
T
T
T
T
T
T
T
T
T T
T
T
T30RW Factory Default Settings
General Tab Default Settings
Setting Factory Default
Response Speed Slow
Signal Strength Threshold 3.0
Target Mode Nearest Target
Measurement Hold Disabled
Discrete Output & Remote Input PNP
Remote Input Wire Disabled
Push Buttons Enabled
Analog Tab Default Settings
Setting Factory Default
Range
4 mA to 20 mA
(0 V to 10 V)
4mA/0V Point 0.3 m (1 ft)
20mA/10V Point 15.0 m (49.2 ft)
Loss of Signal 3.5 mA (0 V)
Averaging 1× (no averaging)
Discrete 1 Tab Default Settings
Setting Factory Default
Output Mode Switch Point
Setpoint 1 15.0 m (49.2 ft)
Hysteresis 0.05 m (2 in)
NO/NC Normally Open
Continued on page 26
© Banner Engineering Corp.