Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN USA 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]
SureCross™ DX99 Battery Board Replacement
P/N 152783
The manufacturer does not take responsibility for the violation of any warning listed in this
document.
CAUTION. Make no modifications to this product.
Any modifications to this
product not expressly approved by Banner Engineering could void the user’s
authority to operate the product. Contact the Factory for more information.
Lightning Arrestors/Surge Protection
. Always use lightning arrestors/surge protection
with all remote antenna systems to avoid invalidating the Banner Engineering Corp.
warranty. No surge protector can absorb all lightning strikes. Do not touch the SureCross
device or any equipment connected to the SureCross device during a thunderstorm.
WARRANTY
. Banner Engineering Corp. warrants its products to be free from defects for
one year. Banner Engineering Corp. will repair or replace, free of charge, any product
of its manufacture found to be defective at the time it is returned to the factory during
the warranty period. This warranty does not cover damage or liability for the improper
application of Banner products. This warranty is in lieu of any other warranty either
expressed or implied.
All specifications published in this document are subject to change. Banner reserves
the right to modify the specifications of products, prior to their order, without notice.
Banner Engineering reserves the right to update or change documentation at any time.
For the most recent version of any documentation, please refer to our website: www.
bannerengineering.com. © 2010 Banner Engineering Corp. All rights reserved.
8. Place the plastic spacer inside the battery chamber
as shown in the photo to the right. There is a cutout to
allow the spacer to fit around the screw mount.
9. Insert the blue and gray power wires into the hole in the
chamber and place the new battery board on top of the
plastic spacer.
10. Replace the three mounting screws. Do not overtighten
the screws as this may damage the battery board.
11. Turn the metal housing over and connect the battery
wires back to the wiring board pigtail.
12. Screw the wiring board back into place.
13. Mount the radio board onto its pins.
14. Replace the metal caps on both chambers.