Banner Sure Cross Performance DX83A Скачать руководство пользователя страница 14

Страница: 14 / 105

3 Setting Up Your Wireless Network

To set up and install your wireless network, follow these steps.

Disconnect the power from your Sure Cross devices.
1. Configure the DIP switches of all devices. For DIP switch configurations, refer to the product's datasheet.
2. If your device has I/O, connect the sensors to the Sure Cross devices. For available I/O, refer to the product's

datasheet. If your device does not have I/O, skip this step.

3. Refer to the wiring diagrams to apply power to all devices.

•

For two LED models, the Gateway's LED 1 is solid green and the Node's LED 2 flashes red to indicate there is no

radio link to the Gateway.

•

For one LED models, the Gateway's LED is solid green and the Node's LED flashes red to indicate there is no radio

link to the Gateway.

4. Form the wireless network by binding the Nodes to the Gateway.
5. Observe the LED behavior to verify the devices are communicating with each other.

•

For two LED models, the Gateway's LED 1 is solid green and the Node's LED 1 flashes green to indicate it is

communicating with the Gateway.

•

For one LED models, the Gateway's LED is solid green and the Node's LED flashes green to indicate it is

communicating with the Gateway.

6. Configure any I/O points to use the sensors connected to the Sure Cross devices.
7. Conduct a site survey between the Gateway and Nodes.
8. Install your wireless sensor network components.

3.1 Using Extended Address Mode

Using extended address mode isolates networks from one another by assigning a unique code, the extended address code,

to all devices in a particular network. Only devices sharing the extended address code can exchange data.

In addition to isolating networks, using extended addressing mode allows you to use up to 47 Nodes with a single

Gateway. Without extended addressing, only 15 Nodes can communicate with a single Gateway.

The extended address code in the Gateway defaults to a code derived from its serial number, although the code can be

customized using the manual binding procedure. Binding DX80 devices "locks" Nodes to a specific Gateway by teaching the

Nodes the Gateway’s extended address code. After the devices are bound, the Nodes only accept data from the Gateway

to which they are bound.

Important: All SureCross Performance Gateways and Nodes are preconfigured for extended addressing mode and

cannot use rotary dial address mode. Skip this step in the installation procedure for Performance products.

For all other SureCross DX80 models, follow these steps to activate

extended address mode. After making any changes to DIP switch settings,

you must cycle power to the device or the DIP switch changes will not be

recognized.

1. Disconnect the Gateway and its Nodes* from their power source.
2. Remove the top covers of all radios.
3. Move DIP switch 1 to the ON position. (Refer to the Device

Configuration section of the device's data sheet for instructions on

accessing the DIP switches.)

4. Apply power to the radios.

* To cycle power to devices with batteries integrated into the housing,

remove the battery for one minute.

3.2 Using Performance and Non-Performance Radios in the Same

Network

To comply with federal regulations, the 150 mW radios and 1 Watt radios communicate differently. To mix Performance

radios with non-Performance radios:

•

Operate Performance radios in 250 mW mode to communicate with non-Performance radios (DIP switch 1 ON)

•