background image

Datasheet

Sure Cross

®

 

MultiHop

 data radios are wireless industrial 

communication

 devices that extend the range of a Modbus or other serial

communication

 network.

900 MHz

2.4 GHz Model

• Wireless industrial I/O device with four sinking discrete inputs, two NMOS discrete

outputs, four 0 to 20 mA analog inputs, and two switch power outputs

• Selectable transmit power levels of 250 mW or 1 

Watt

 for 900 MHz models and 65 mW

for 2.4 GHz models

• FlexPower

®

 power 

options

 allow for 10 to 30 V dc, solar, and 

battery

 power sources for

low power 

applications.

• Self-healing, 

auto-routing

 RF network with 

multiple

 hops extends the network’s range

• Serial and I/O 

communication

 on a Modbus 

platform

• Message 

routing

 improves link performance

• DIP switches select 

operational

 modes: master, repeater, or slave

• Built-in site survey mode enables rapid assessment of a 

location’s

 RF transmission

properties

• FHSS radios operate and synchronize 

automatically

For 

additional

 

information,

 updated 

documentation,

 and a list of accessories, refer to Banner Engineering's website, 

www.bannerengineering.com/wireless

.

WARNING: Not To Be Used for Personnel 

Protection

Never use this device as a sensing device for personnel 

protection.

 Doing so could lead to serious injury or death.

This device does not include the self-checking redundant circuitry necessary to allow its use in personnel safety

applications.

 A sensor failure or 

malfunction

 can cause either an energized or de-energized sensor output

condition.

CAUTION: Never Operate 1 

Watt

 Radios Without Antennas

To avoid damaging the radio circuitry, never power up Sure Cross

®

 Performance or Sure Cross 

MultiHop

 (1 

Watt)

radios without an antenna.

CAUTION: 

Electrostatic

 Discharge (ESD)

ESD 

Sensitive

 Device. This product uses semiconductors that can be damaged by 

electrostatic

 discharge (ESD).

When performing maintenance, care must be taken so the device is not damaged. Disconnect power from the

device when accessing the internal DIP switches. Proper handling procedures include wearing 

anti-static

 wrist

straps. Damage from inappropriate handling is not covered by warranty.

Models

Models

Frequency

I/O

DX80DR9M-H5

900 MHz ISM Band

Inputs: Four NPN discrete, four 0 to 20 mA analog
Outputs: Two NMOS discrete
Switch Power: Two
Serial interface: RS-485

DX80DR2M-H5

2.4 GHz ISM Band

DX80...C (IP20; NEMA 1) models are also available. To order this model with an IP20 housing, add a C to the

end of the model number: DX80DR9M-H5C.

Sure Cross

®

 

MultiHop

 Data Radio

 

 

Original Document

152416 Rev. H

22 September 2017

152416

Содержание Sure Cross MultiHop DX80DR9M-H5









Отзывы: